Sanyo LNS-W03 Manual de usuario descargar pdf

Type of the Cabinet (1) See Page 2

LCD PROJECTOR LENS

MODEL NO. LNS-W03

LENS REPLACEMENT

AND INSTALLATION PROCEDURES

NOTES ON REPLACEMENT AND INSTALLATION

The procedures and the needed pars for lens installation depend on the type of

cabinet. Before installing or replacing the lens, make sure the type of cabinet and be

sure to refer to the Installations corresponding with your projector.

When installing or replacing the lens, make sure the Lens Model No. matches with

your projector. Refer to the catalog, or contact your sales dealer for the proper Lens

Model No.

TYPE OF THE CABINET AND INSTALLATION PROCEDURES

Refer to the Installation procedure corresponding to your projector and install the lens

correctly. (See the chart below.)

Type of the Cabinet (2) See Page 4

1AA6P1P2952-- (ICYZ)

For use the other models (other than above cabinet), contact your sales dealer.

1 2 3 4 5 6 7

Indice de contenidos

Pagina 1 - AND INSTALLATION PROCEDURES

Type of the Cabinet (1) See Page 2LCD PROJECTOR LENSMODEL NO. LNS-W03LENS REPLACEMENT AND INSTALLATION PROCEDURESNOTES ON REPLACEMENT AND INSTALLATION

Pagina 2 - NOTES ON LENS INSTALLATION

Some parts are not used for installation or replacement. Keep these parts for later use.Note : Figures in this manual may be differ from the actual p

Pagina 3 - (Type 1 Cabinet)

LENS REPLACEMENT AND INSTALLATION PROCEDURE1. Remove screws A (2 screws).2. Pull down the lower lens cover while pushingthe part D, then remove it.3.

Pagina 4 - ADJUST FOCUS

MOUNT THE LENS COVER. (See figure-6)INSTALL THE LENS. (See figure-4)1. Remove protective caps(front andback) on the lens.2. Mount the lens on mounting

Pagina 5 - (Type 2 Cabinet)

1. Remove screws A (2 screws).2. Push part B and pull Upper Lens Cover up.1Fig-1Fig-22REMOVE THE UPPER LENS COVER. (See figure-1)(At the step , insert

Pagina 6

INSTALL THE LENS. (See figure-5)1. Remove protective caps(front andback) on the lens.2. Mount the lens on mounting bracketof the main cabinet with 4 s

Pagina 7 - FOCUS ADJUSTMENT

FOCUS ADJUSTMENTSet up the projector and project image on the screen.1. Loosen the Focus Lock Screw on the projectionlens.2. Rotate the projection len