Sanyo Projector PLC-XE32MODEL Manual de usuario descargar pdf (Pagina 11)

9

Part Names and Functions

Part Names and Functions

Rear Terminal

① ② ③ ④ ⑤ ⑥

⑦

① SERVICE PORT

This jack is used to service the projector.

② COMPUTER IN 1 / S-VIDEO IN

/COMPONENT IN

Connect output signal from a computer,

RGB scart 21-pin video output, S-VIDEO

output, or component video output to this

terminal. (p.15-17)

When the cable is of the longer variety, it

is advisable to use this terminal and not

COMPUTER IN 2 / MONITOR OUT.

④ AUDIO OUT (VARIABLE)

Connect an external audio amplifier to this

jack. (p.15 - 17)

This terminal outputs sound from AUDIO IN

terminal (⑤ or ⑦).

⑥ VIDEO IN

Connect the composite video output from

video equipment to VIDEO jack. (p.16)

⑦ AUDIO IN

Co nnect the audi o out put from video

equipment connected to ⑥ to this jack.

(W hen the audio outp u t i s mon aural,

connect it to L (MONO) jack.) (p.16)

⑤ COMPONENT / COMPUTER AUDIO IN

Connect the audio output (stereo) from a

computer or video equipment connected to

② to this jack. (p.15, 17)

③ COMPUTER IN 2 / MONITOR OUT

This terminal is switchable and can be used

for input from a computer or output to the

other monitor. (p.15, 17)

Set the terminal up as either Computer

input or Monitor output properly. (Use

for Monitor out, this terminal output only

incoming signal from COMPUTER IN 1/

S-VIDEO IN/COMPONENT IN terminal.)

(p.15,17,45)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 67 68

Comentarios a estos manuales

Sin comentarios