Sanyo KS1872 Manual de usuario Pagina 13
- Pagina / 25
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
13
When connecting each power wire to the corresponding
terminal, follow the instructions “How to connect wiring
to the terminal” and fasten the wire securely tight with
the fixing screw of the terminal plate.
How to connect wiring to the terminal
a) For Indoor Unit
(1) Cut the wire end with a cutting pliers, then strip the
insulation to expose the wire about 9/32" (7 mm).
See the label (Fig. 28) near the terminal plate.
(2) Using a screwdriver, loosen the terminal screw on
the terminal plate.
(3) Insert the wire and tighten the terminal screw com-
pletely using a screwdriver.
b) For Outdoor Unit
I For solid core wiring (or F-cable)
(1) Cut the wire end with a cutting pliers, then strip the
insulation to expose the solid wire about 15/16" (25
mm). (Fig. 29)
(2) Using a screwdriver, remove the terminal screw(s)
on the terminal plate.
(3) Using the pliers, bend the solid wire to form a loop
suitable for the terminal screw.
(4) Shape the loop wire properly, place it on the termi-
nal plate and fix it securely with the removed termi-
nal screw using a screwdriver.
I For stranded wiring
(1) Cut the wire end with a cutting pliers, then strip the
insulation to expose the stranded wiring about 3/8"
(10 mm) and tightly twist the wire ends. (Figs. 30
and 31)
(2) Using a screwdriver, remove the terminal screw(s)
on the terminal plate.
(3) Using a ring connector fastener or pliers, securely
clamp each stripped wire end with a ring connector.
(Fig. 30)
(4) Place the ring connector wire, and replace and
tighten the removed terminal screw using a screw-
driver. (Fig. 32)
Solid wire
Loop
Insulation
Strip 15/16" (25 mm)
Fig. 29
STRIP
SIZE
9/32"
(7 mm)
(ACTUAL
SIZE)
Fig. 28
Stranded wire
Ring
connector
Strip 3/8" (10 mm)
Fig. 30
Screw
Ring connector
Terminal plate
Wire
Special
washer
Fig. 32
Screw and
special washer
Ring
connector
Wire
WARNING
Loose wiring may cause the
terminal to overheat or result
in unit malfunction. A fire
hazard may also exist. There-
fore, be sure all wiring is
tightly connected.
Twist wire ends
Fig. 31
05-326 AirCon_85264189988000 12/5/05 3:35 PM Page 13
- INSTALLATION INSTRUCTIONS 1
- Please Read Before Starting 2
- IMPORTANT! 2
- 1. General 3
- About 1'4" (40 cm) 5
- Rear panel 7
- 3/16" 8
- (4.8 mm) dia. hole 8
- Rawl plug 8
- OUTDOOR 11
- Strip 15/16" (25 mm) 13
- Strip 3/8" (10 mm) 13
- Padding material 14
- 5. Refrigerant Tubing 18
- Insulated tubes 19
- Apply putty here 19
- 6. Air Purging 20
- Pump Down 23
- 8. Address Switch 25
Carrier Generatori elettrici manuali utente
La lista di Carrier Generatori elettrici prodotti contiene 14 manuali utenti per 10 modelli. Tutte le guide utenti pdf sono disponibili per essere scaricate o visionate online.
Comentarios a estos manuales