Sanyo POA-CH-EX06 Manual de instalación Pagina 1

Installation ManualSetting Plate for Wall HangingModel POA-CH-EX06ContentsSafety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . .

9Attach the drop-prevention wire to the projectorTo prevent the projector from falling down, use the included drop-prevention wire to connect the proj

10EnglishProjection Distance Table●SANYO PDG-DWL2500 Unit: inch (cm)Display Size ABCDEH110" (16 : 10) 21.45" (54.5) 17.91" (45.5) 6.25

11DimensionsUnit: inch (mm)6.45 (164)Center line of the projection surface18.23 (463)15.83 (402)15.16 (385)15.16 (385)14.88 (378)6.85 (174)6.69 (170)2

1 Explanation of SymbolsThe warning marks shown below are used in this manual to prevent personal injury or property dam-age. Make sure you understan

2EnglishCAUTIONDo not install the setting plate in a location where the operating temperature for your projector model may be exceeded. Such an enviro

3List of Accessoriesq Wall plate . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1w Setting plate . . . . . . . . . . . . . . . . . . . .

4EnglishInstallation ProcedureInstall the wall plate to the wall1Determine the position of the wall plate using the template sheet.From the projection

5Installation ProcedureAttach the setting plate to the wall plate1Hang the setting plate hook onto the wall plate slits.2Tighten the four M8 x 20 mm h

6EnglishInstallation ProcedureSecuring the projector to the setting plate1Attach the adjustment unit to the projector using the included 5 screws (M4

7Installation ProcedureAdjustment1Adjust the forward/backward slide (Adjustable range: 0 - 180 mm)Loosen the four bolts on the top of the setting ¡pl

8EnglishInstallation Procedure4Adjust the vertical tilt (Adjustable range: +5° - –5°)Loosen the screw ¡q located on the left side of the setting plat